Power cable connection procedure is explained.

•	Be sure to use the power cable supplied with the plotter. If other power cables are used, it would cause an electric shock or fire.
•	Do not use damaged power cable. It could lead to an electric shock and fire.

•

Pay attention to the following points, while handling power cable.

•	Do not do anything forcefully on the power cable.
•	Do not keep heavy objects on the power cable.
•	Do not bend, twist or pull the power cable by force.
•	Do not route the power cable near heating appliances.

•	Contact MUTOH local dealer in case of power cable damage.

Install the ink cartridge as shown in the following procedure.

Make sure that the plotter power is turned OFF.

•	Power is turned ON when the [Power] key of operation panel is pressed. Press the key once again and turn OFF the power.

Connect the power cable to the AC inlet on the back of the plotter.

No.

Name

AC inlet

Power cable

Power cable plug is correctly inserted in the socket.

•

Do not take out or insert power plug with a wet hand. This could lead to an electric shock.

•

Make sure to use only the specified power supply (AC 100 V - 120 V or AC 220 V - 240 V). If the power supply other than the specified voltage is used, it could cause an electric shock and fire.

•

Take power for the plotter directly from the power socket (AC 100 V - 120 V or AC 220 V - 240 V). Do not use complex multiple plugs on the same socket. This could generate heat and might cause fire.

•

Make sure to use dedicated power socket with earth terminal for power supply, and connect an earth terminal to it. If the earth wire is not connected, an electric shock or fire may occur.

•

Do not connect an earth wire to the following places.

•	Gas pipe There is a possibility of ignition and explosion.
•	Earth wire of telephone cables and lightning rods Heavy current might flow whenever a lightning strikes.
•	Water pipe and faucet The earth might not work if a plastic pipe is connected in the middle of the metal pipe.

•

Pay attention to the following points while handling power supply plug. Any mishandling of the power cable could cause a fire.

•	Make sure that no foreign substances such as dust etc. are stuck to the power plug.
•	The power plug is firmly inserted to the edge of the power socket.

•

If the plotter is not used for a longer period, make sure to pull out the power plug from the power socket for safety.

•

Make sure to connect an earth wire to the earth connection which meets the following standards.

•	Earth terminal of power socket
•	Earth wire with copper plate which is buried at 650 mm or more, deep in the ground.

•	Contact the retail outlet of purchase, when the earth connection cannot be established, or when the earth connection is not given.
•	Do not pull out the power cable from the power socket, while the power supply of the plotter is ON. Whenever the plug is pulled out from the power socket, allow one minute or more before inserting the plug in the power socket again.

No.

Name

Power plug