| Error messages | Cause | Solution |
|---|---|---|
| E74 TRANS DATA | E74 TRANS DATA Received data is not Version Up file. | Turn OFF the power to the machine and turn it ON again after a while. If the same error message appears again,contact our service office or the distributor in your region. |
| E80 ROM0 ERASE | ROM Erase error. | |
| E81 ROM1 ERASE | ROM Erase error. | |
| E82 h'******** | ROM Write error. | |
| E83 h'******** | ROM Write error. | |
| E85 ROM HASH | The mistake was found in the written data. | |
| E90 h'******** | ROM Erase error. | |
| E92 h'******** | ROM Write error. | |
| E98 I/F FORMAT | Wrong version up data. | |
| E111 NCU ROM 00 | Dot check F-ROM ERASE error.(at Version Up) | |
| E111 NCU ROM 01 | Dot check F-ROM VERIFY error.(at Version Up) | |
| E111 NCU ROM 02 | Dot check F-ROM WRITE error.(at Version Up) | |
| E114 NCU ROM HASH | Hash check error.(at Version Up) | |
| E116 NCU I/F 00 | An error occurred in communication between the NCU PCB and the control board. | |
| E116 NCU I/F 01 | ||
| E119 NCU NONE | NCU is not connected.(at Version Up) | |
| E164 NCU FPGA | FPGA configuration failure. |